Welcome

Vision Engraving and Routing Systems, has been manufacturing high quality affordable engraving machines, CNC routers and accessories in the USA since 1983.

Vision Website

Vision Website

Click below to visit our website wwww.visionengravers.com.
Read More
Machine Videos

Machine Videos

Click below to watch our videos of our machines in action!
Read More
Machines

Machines

Click below to view our Engraving and CNC Routing Machines.
Read More
Machine Demo

Machine Demo

Watch a live online demo of our machines before you buy!
Read More

Filter By Color

Using Filter By Color in the Vision software is a good way to control what is run and in what order when sending jobs over to your engraver.

Filter By Color can be very useful when designing a job in the Vision software that involves engraving and cutting through the material or if different tools/ tool paths are used.  Filter By Color can be set as a default for any driver or manually enabled when sending a job to the machine.

A good example for the Filter By Color is a tag that needs to be engraved and cutout.  This 2”x4” tag has online tool path for the text, a female tool path for the mounting holes, and a male tool path for the cutout of the tag- 3 different tool paths with 2 tools.  Order is important- inside cuts and engraving first, final cutout is last. 

Send over the whole job (the Engrave button on the left Icon bar), then click on Filter By Color.

Another window pops up and from here you can drop down the color bar and pick which color to run first.

Click on the color to run first and make sure you have the correct Material setting, then click Select, then click Engrave on the Cut Toolbar, which will send the job to the machine.

Stacking the jobs is not recommended (send over more than 1 color at a time).  Sending over individually allows you to dry run if needed or rerun the job you just did (i.e. the engraving wasn’t deep enough) and if you stack the jobs, it can be confusing about what tool and when.

After the first color is sent over, drop down the color bar and click on the next color to run and click the Engrave button which sends over the job.  When you drop the color bar down, notice that the previously sent color/s are crossed out showing that is was sent but you can still send it over again if needed. The Select button under the Engrave button can be used to check what you are sending before running it.

***Remember to change the Material setting as needed before sending over the color (i.e. going from engraving to cutout or cut through-Engraver’s plastic engraving to Engraver’s plastic cutter/beveler***

After the last job has been sent over to the machine (make sure it is actually at the machine), just click on Stop Cutting.

Hopefully this helps, check back next month for another Quick Tip, and remember to check the archives in Quick Tips.