There are five positions that you can set the spindle to move to once a job is completed. This is known as “Parking”.
On the Series 4 Pendant, go to Menu> Configuration> Parking
None: The spindle will remain at its last location when the job is finished.
Z-Up: The spindle will remain at its last location at the end of the file and lift the spindle off the material.
Home: The spindle will move to the current home position that is set in the controller.
Datum: The spindle will move back to the limit switch position on the table.
Z Lift: The spindle will move up to a specified Z Lift position, then go to the current home position; Z lift positioning can be specified under Menu> Configuration> Parking Z Lift
Social tagging: computerized engraving equipment > engraving equipment > Series 4 controller > Vision Engraving & Routing Systems